Detailing Lab
How to apply The Last Coat 2.0 (TLC2) ceramic coating
A section-by-section application of the TLC2 spray ceramic coating, from a clean car to a cured finish.
- Surface
- Painted exterior
- Time
- A few minutes per section before buffing; keep dry about 24 h
- Amount
- A few drops on the applicator per section
You’ll need
- The Last Coat 2.0
- Microfiber applicator
- Clean microfiber towels
- 70% isopropyl alcohol (IPA) for the final wipedown
- Clay bar or mitt, if the paint is contaminated
Prep
- Wash the car thoroughly and let it dry.
- Decontaminate with a clay bar or mitt if the paint feels rough.
- Inspect the paint and correct defects or scratches before applying the coating.
- Work in the shade; avoid hot panels and direct sunlight.
Steps
- Shake the bottle well.
- Put a few drops on the applicator — a small amount for each section.
- Spread on one small section in straight lines for even coverage.
- Let it cure for a few minutes (depends on temperature and humidity).
- Buff off the residue with a clean microfiber towel until smooth and glossy.
- Repeat section by section around the car.
- Once fully applied, do an IPA wipedown with 70% isopropyl alcohol to remove remaining residue.
Common mistakes
- Applying in direct sun or on a hot panel.
- Using too much product per section.
- Letting the car get wet before the ~24 h cure.
- Coating over contamination or scratches you meant to fix.
Safety & care
- Follow the instructions on the product label for application and cure times.
Source: BOMgoods guide, first published 2023-08-22. Always follow the product label.